Diamondlab
Book a lab visit

Incubator · Surface cleaning

Investigating innovative cleaning techniques

Shared research facility · 6 incubator bays 6 weeks · 108 coupon runs

Effective disinfectants and surface coatings were compared across a controlled incubation protocol to reduce the spread of infectious agents in shared facilities.

Laboratory work for this case study

The problem

A shared research facility reported recurring contamination in two incubator bays. Swab results varied between technicians, so it was impossible to tell whether the cleaning agents, the application routine or the incubation conditions were responsible. The facility needed a comparison it could repeat, not a single before-and-after swab.

The method

Six cleaning regimes were applied to matched stainless-steel coupons and incubated alongside the live bays. Each regime ran in triplicate with a positive and a negative control, an untreated coupon carried through the same handling steps, and neutraliser validation to confirm the disinfectant was actually stopped at sampling. Coupons were swabbed at 0, 4 and 8 hours with a fixed template area.

The result

Two regimes reduced recoverable organisms by more than three log steps at 4 hours, and residue testing showed no accumulation after eight consecutive cycles. The remaining four regimes were indistinguishable from the untreated control at the 8-hour point. The facility moved to one of the effective regimes and added a documented neutraliser step to its routine swabbing.

Back to all case studies

Next step

Bring us the observation you already have

A case usually starts with a result that does not separate cause from coincidence. That is enough to begin.